en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Obě strany předchozí revizePředchozí verze | |||
en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:40] – ondra | en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:41] (aktuální) – ondra | ||
---|---|---|---|
Řádek 16: | Řádek 16: | ||
\\ | \\ | ||
**Sensors** \\ | **Sensors** \\ | ||
- | If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </ | + | If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </ |
+ | **Inputs** \\ | ||
When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\ | When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\ | ||
\\ | \\ | ||
Řádek 23: | Řádek 24: | ||
\\ | \\ | ||
**Sending production report** \\ | **Sending production report** \\ | ||
- | A production report (selected type of message) is sent to the user in preset intervals.\\ | + | A production report (selected type of message) is sent to the user in preset intervals.\\ \\ |
==== Devices State ==== | ==== Devices State ==== | ||
- | |||
- | |||
If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately. | If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately. | ||
en/sim/manual/dohled_a_upozorneni/monitoring_a_alarmy.txt · Poslední úprava: 2018/06/18 13:41 autor: ondra