This shows you the differences between two versions of the page.
en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:40] ondra |
en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:41] (current) ondra |
||
---|---|---|---|
Line 16: | Line 16: | ||
\\ | \\ | ||
**Sensors** \\ | **Sensors** \\ | ||
- | If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP> **Inputs** \\ | + | If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP> |
+ | **Inputs** \\ | ||
When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\ | When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\ | ||
\\ | \\ | ||
Line 23: | Line 24: | ||
\\ | \\ | ||
**Sending production report** \\ | **Sending production report** \\ | ||
- | A production report (selected type of message) is sent to the user in preset intervals.\\ | + | A production report (selected type of message) is sent to the user in preset intervals.\\ \\ |
==== Devices State ==== | ==== Devices State ==== | ||
- | |||
- | |||
If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately. | If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately. | ||