en:sim:manual:jak_na_instalaci:fronius_layout
no way to compare when less than two revisions
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Předchozí verzeNásledující verze | |||
— | en:sim:manual:jak_na_instalaci:fronius_layout [2014/09/19 15:35] – ondra | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
+ | ===== Connection Diagram ===== | ||
+ | ---- | ||
+ | |||
+ | {{ .: | ||
+ | \\ | ||
+ | In a similar way, you can connect SM2 to connector OUT. Then terminator is connected to IN at the end of the bus (apply either when connecting to one inverter). In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\ | ||
+ | {{ .: | ||
+ | \\ \\ | ||
+ | ===== RJ45 Connector Pinout ===== | ||
+ | <WRAP left> | ||
+ | === SM2 - Fronius IN === | ||
+ | ^ PIN | Name ^ | ||
+ | ^ 1 | +12V ^ | ||
+ | ^ 2 | GND ^ | ||
+ | ^ 3 | Tx+ ^ | ||
+ | ^ 4 | Rx+ ^ | ||
+ | ^ 5 | Rx- ^ | ||
+ | ^ 6 | Tx- ^ | ||
+ | ^ 7 | GND ^ | ||
+ | ^ 8 | +12V ^ | ||
+ | </ | ||
+ | <WRAP right> | ||
+ | === SM2 - Fronius OUT === | ||
+ | ^ PIN | Name ^ | ||
+ | ^ 1 | +12V ^ | ||
+ | ^ 2 | GND ^ | ||
+ | ^ 3 | Rx+ ^ | ||
+ | ^ 4 | Tx+ ^ | ||
+ | ^ 5 | Tx- ^ | ||
+ | ^ 6 | Rx- ^ | ||
+ | ^ 7 | GND ^ | ||
+ | ^ 8 | +12V ^ | ||
+ | </ | ||
+ | ===== Configuration Notes ===== | ||
+ | {{.: | ||
+ | \\ \\ \\ \\ \\ \\ | ||
+ | <WRAP left> | ||
+ | [[..: | ||
+ | </ | ||
+ | |||
+ | |||
+ | |||
+ | |||
en/sim/manual/jak_na_instalaci/fronius_layout.txt · Poslední úprava: 2015/02/17 13:02 autor: ondra