Differences

This shows you the differences between two versions of the page.

--- en:sim:manual:jak_na_instalaci:fronius_layout [2014/09/17 13:56]
ondra created
+++ en:sim:manual:jak_na_instalaci:fronius_layout [2015/02/17 13:02] (current)
ondra
@@ Line 1: / Line 1: @@
-===== Interface Signal Layout =====
+===== Connection Diagram =====
 ----
+<WRAP half column>
+Connection Fronius to SM2-MU
+{{.:rs485_fronius.png?&250 |}}
+</WRAP>
+<WRAP half column>
+{{ .:sm2_fronius_in.png?&300 |}} \\ \\
+</WRAP>
+\\
+In a similar way, you can connect SM2 to connector OUT. Then terminator is connected to IN at the end of the bus (apply either when connecting to one inverter). In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\
+{{ .:fronius_terminator.png?nolink&300 |}}
+\\ \\
+===== RJ45 Connector Pinout =====
+<WRAP left>
+=== SM2 - Fronius IN ===
+^  PIN  |  Name  ^
+^  1  |  +12V  ^
+^  2  |  GND  ^
+^  3  |  Tx+  ^
+^  4  |  Rx+  ^
+^  5  |  Rx-  ^
+^  6  |  Tx-  ^
+^  7  |  GND  ^
+^  8  |  +12V  ^
+</WRAP>
+<WRAP right>
+=== SM2 - Fronius OUT ===
+^  PIN  |  Name  ^
+^  1  |  +12V  ^
+^  2  |  GND  ^
+^  3  |  Rx+  ^
+^  4  |  Tx+  ^
+^  5  |  Tx-  ^
+^  6  |  Rx-  ^
+^  7  |  GND  ^
+^  8  |  +12V  ^
+</WRAP>
+===== Configuration Notes =====
+{{.:fronius_rady.png?nolink&500  |}}
+\\ \\ \\ \\ \\ \\
+<WRAP left>
+[[..:jak_na_instalaci:stridace|<< Back]]
+</WRAP>
-{{ .:sm2_fronius.png?nolink |}}