en:sim:manual:jak_na_instalaci:fronius_layout
Differences
This shows you the differences between two versions of the page.
|
en:sim:manual:jak_na_instalaci:fronius_layout [2014/09/26 13:16] ondra |
en:sim:manual:jak_na_instalaci:fronius_layout [2015/02/17 13:02] (current) ondra |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Connection Diagram ===== | ===== Connection Diagram ===== | ||
| ---- | ---- | ||
| - | + | <WRAP half column> | |
| - | {{ .:sm2_fronius_in.png?nolink&500 |}} | + | Connection Fronius to SM2-MU |
| + | {{.:rs485_fronius.png?&250 |}} | ||
| + | </WRAP> | ||
| + | <WRAP half column> | ||
| + | {{ .:sm2_fronius_in.png?&300 |}} \\ \\ | ||
| + | </WRAP> | ||
| \\ | \\ | ||
| In a similar way, you can connect SM2 to connector OUT. Then terminator is connected to IN at the end of the bus (apply either when connecting to one inverter). In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\ | In a similar way, you can connect SM2 to connector OUT. Then terminator is connected to IN at the end of the bus (apply either when connecting to one inverter). In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\ | ||
en/sim/manual/jak_na_instalaci/fronius_layout.txt · Last modified: 2015/02/17 13:02 by ondra
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
