en:sim:manual:jak_na_instalaci:schneider
Differences
This shows you the differences between two versions of the page.
|
en:sim:manual:jak_na_instalaci:schneider [2014/09/30 11:04] ondra |
en:sim:manual:jak_na_instalaci:schneider [2015/02/17 13:16] (current) ondra |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ===== Connection Diagram ===== | ===== Connection Diagram ===== | ||
| ---- | ---- | ||
| + | <WRAP half column> | ||
| + | Connection Schneider to SM2-MU | ||
| + | {{.:rs485_schneider.png?&250 |}} | ||
| + | </WRAP> | ||
| + | <WRAP half column> | ||
| {{ .:schneider.png?nolink&500 |}} \\ \\ | {{ .:schneider.png?nolink&500 |}} \\ \\ | ||
| + | </WRAP> | ||
| In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\ | In case of the involvement of multiple inverters, connect the inverters with straight cable. \\ \\ | ||
| Set the termination on the last communication card (both DIP switches to same position) | Set the termination on the last communication card (both DIP switches to same position) | ||
en/sim/manual/jak_na_instalaci/schneider.txt ยท Last modified: 2015/02/17 13:16 by ondra
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
