User Tools

Site Tools


en:sim:manual:jak_na_instalaci:steca

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

en:sim:manual:jak_na_instalaci:steca [2018/03/22 00:06]
ondra created
en:sim:manual:jak_na_instalaci:steca [2018/05/25 15:21] (current)
ondra
Line 1: Line 1:
 ===== Connection Diagram ===== ===== Connection Diagram =====
-{{ .:sm2_mu_steca_scheme.png?direct |}}+==== 1a) SM2-MU – master for all devices ==== 
 +For power supply see Power Supply section. 
 +All individual Taroms connected as slaves - data are read from each device. 
 +{{ .:​sm2_mu_steca_slave_scheme.png?​direct |}} 
 +\\ \\ 
 +==== 1b) Multiple Tarom 6000-M on a single RS485 bus ==== 
 +{{ .:​sm2_mu_steca_master_scheme.png?​direct |}} 
 +\\ \\ 
 +1a) and 1b) can be mixed \\ 
 +Both 1a) and 1b) can be used for each SM2-MU interface. \\ 
 +For short cables terminator is not necessary. 
 +\\ \\ 
 +==== 1c) SM2-MU can be placed in the middle of RS485 bus ==== 
 +For this case SM2-MU must be used with RS485 terminator switched off. Use yellow DIP switches to achieve this. 
 +{{ .:​sm2_mu_steca_master_scheme_switched_off.png?​direct |}} 
 +\\ \\ 
 +==== 1d) Second SM2-MU serial interface can be used for additional Tarom device. ==== 
 +{{ .:​sm2_mu_steca_master_scheme_2_branches.png?​direct |}} 
 + 
 +\\ \\ 
 +==== 1e) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ==== 
 +MPPT 6000-S as slaves to MPPT 6000-M 
 +{{ .:​sm2_mu_steca_master_and_slave_connection.png?​direct |}} 
 +\\ \\ 
 +==== 1f) SM2-MU + Tarom 4545 ==== 
 +{{ .:sm2_tarom4545.png?direct |}}
 \\ \\ \\ \\
 **Detection** **Detection**
-{{ .:​detection.png?​direct |}}+{{ .:​detection.png?​direct |}} \\ \\ 
 +<WRAP left> 
 +[[..:​jak_na_instalaci:​stridace|<<​ Back]] 
 +</​WRAP>​
en/sim/manual/jak_na_instalaci/steca.1521673614.txt.gz · Last modified: 2018/03/22 00:06 by ondra