This shows you the differences between two versions of the page.
en:sim:manual:jak_na_instalaci:steca [2018/03/26 09:35] ondra |
en:sim:manual:jak_na_instalaci:steca [2018/05/25 15:21] (current) ondra |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Connection Diagram ===== | ===== Connection Diagram ===== | ||
+ | ==== 1a) SM2-MU – master for all devices ==== | ||
+ | For power supply see Power Supply section. | ||
+ | All individual Taroms connected as slaves - data are read from each device. | ||
{{ .:sm2_mu_steca_slave_scheme.png?direct |}} | {{ .:sm2_mu_steca_slave_scheme.png?direct |}} | ||
+ | \\ \\ | ||
+ | ==== 1b) Multiple Tarom 6000-M on a single RS485 bus ==== | ||
{{ .:sm2_mu_steca_master_scheme.png?direct |}} | {{ .:sm2_mu_steca_master_scheme.png?direct |}} | ||
+ | \\ \\ | ||
+ | 1a) and 1b) can be mixed \\ | ||
+ | Both 1a) and 1b) can be used for each SM2-MU interface. \\ | ||
+ | For short cables terminator is not necessary. | ||
+ | \\ \\ | ||
+ | ==== 1c) SM2-MU can be placed in the middle of RS485 bus ==== | ||
+ | For this case SM2-MU must be used with RS485 terminator switched off. Use yellow DIP switches to achieve this. | ||
+ | {{ .:sm2_mu_steca_master_scheme_switched_off.png?direct |}} | ||
+ | \\ \\ | ||
+ | ==== 1d) Second SM2-MU serial interface can be used for additional Tarom device. ==== | ||
+ | {{ .:sm2_mu_steca_master_scheme_2_branches.png?direct |}} | ||
+ | |||
+ | \\ \\ | ||
+ | ==== 1e) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ==== | ||
+ | MPPT 6000-S as slaves to MPPT 6000-M | ||
+ | {{ .:sm2_mu_steca_master_and_slave_connection.png?direct |}} | ||
+ | \\ \\ | ||
+ | ==== 1f) SM2-MU + Tarom 4545 ==== | ||
+ | {{ .:sm2_tarom4545.png?direct |}} | ||
\\ \\ | \\ \\ | ||
**Detection** | **Detection** | ||
- | {{ .:detection.png?direct |}} | + | {{ .:detection.png?direct |}} \\ \\ |
+ | <WRAP left> | ||
+ | [[..:jak_na_instalaci:stridace|<< Back]] | ||
+ | </WRAP> |