en:sim:manual:jak_na_instalaci:stridace
no way to compare when less than two revisions
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Předchozí verzeNásledující verze | |||
— | en:sim:manual:jak_na_instalaci:stridace [2014/10/01 15:10] – ondra | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
+ | ===== Inverters ===== | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | \\ | ||
+ | <WRAP half column> | ||
+ | \\ | ||
+ | \\ | ||
+ | Terminals SM2-MU: A, B, 4GND, Z, Y, or DC+ a DC - are used according to the inverter manufacturer. </ | ||
+ | \\ | ||
+ | </ | ||
+ | \\ | ||
+ | If there is SM at the beginning of H-bus, sliding switches must be in ON position.\\ | ||
+ | \\ | ||
+ | {{ .: | ||
+ | |||
+ | |||
+ | The same for the inverter - if it supports bus termination, | ||
+ | If there is manual address scheme in your inverters, you need to set up addresses, ideally beginning with address 1. E.g. 21: 1, 2, 3, …, 31. Procedure is described in inverter' | ||
+ | |||
+ | |||
+ | ^ SM2-MU | ||
+ | |[[.: | ||
+ | |[[.: | ||
+ | |Carlo Gavazzi | - | - | 5(GND) | ||
+ | |[[.: | ||
+ | |[[.: | ||
+ | |Diehl | - | - | shield | ||
+ | |[[.: | ||
+ | |[[.: | ||
+ | |KOSTAL | - | - | 3 | 2 | 1 | - | - | ✔ | ✔ | 19200 | | ||
+ | |Mastervolt |- | - | - | 3 | 4 | - | - | ✔ | - | 9600 | | ||
+ | |[[.: | ||
+ | |Refusol | - | - | - | 3 | 2 | - | - | ✔ | ✔ | 57600 | | ||
+ | |Santerno |- | - | - | S- |S+ | - | - | ✔ | - | optional | ||
+ | |[[.: | ||
+ | |Siemens | - | - | - | B | A | - | - | ✔ | ✔ | optional | ||
+ | |Siliken | - | - | 5(GND) | ||
+ | |[[.: | ||
+ | |[[.: | ||
+ | |[[.: | ||
+ | |Sunwille | 4(Rx-) | ||
+ | |Vacon | - | - | 5 | 3 | 4 | - | - | ✔ | ✔ | optional | ||
+ | |Xantrex (GT100-630E) | - | - | GND | RxTx- | RxTx+ | - | - | ✘ | optional | ||
+ | |||
+ | |||
+ | \\ | ||
+ | |||
en/sim/manual/jak_na_instalaci/stridace.txt · Poslední úprava: 2019/09/30 11:52 autor: ppodhajska