en:sim:manual:menu_nastaveni:stridace_a_mereni
Differences
This shows you the differences between two versions of the page.
|
en:sim:manual:menu_nastaveni:stridace_a_mereni [2014/07/25 13:37] jitka |
en:sim:manual:menu_nastaveni:stridace_a_mereni [2018/06/08 11:21] (current) ondra |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== Inverters and Meters ===== | + | ===== Find Devices ===== |
| ---- | ---- | ||
| - | + | Submenu find devices enables setting up connected devices (inverters, MPPT trackers, meters) via RS485, RS232, ethernet interfaces.\\ | |
| - | + | ||
| - | Submenu inverters and meters enables setting up inverters and electrometer\\ | + | |
| - | \\ | + | |
| - | {{ :en:sim:manual:menu_nastaveni:stridace_a_mereni.png?nolink& }} | + | |
| - | + | ||
| - | + | ||
| - | ==== Setting up connected inverters according to a particular interface ==== | + | |
| - | + | ||
| - | + | ||
| - | \\ | + | |
| - | Select the type of communication. Relevant information stated in inverter documentation.\\ | + | |
| - | \\ | + | |
| - | [[:en:sim:manual:menu_nastaveni:stridace_a_mereni:485|RS 485]]\\ | + | |
| - | [[:en:sim:manual:menu_nastaveni:stridace_a_mereni:232|RS 232]]\\ | + | |
| - | [[:en:sim:manual:menu_nastaveni:stridace_a_mereni:ethernet|Net interface (Ethernet)]]\\ | + | |
| \\ | \\ | ||
| - | ==== How to set up measuring the energy ==== | + | {{ .:stridace_a_mereni.png?nolink& }} |
| - | **Number of pulses per 1 kWh** \\ | + | ==== Setting up communication of connected devices according to a particular interface ==== |
| - | More info on setting up the number of pulses in chapter [[:en:sim:manual:jak_na_instalaci:elmer|Electro meter]].\\ | + | Select the type of communication. Relevant information is stated in documentation for the device.\\ |
| \\ | \\ | ||
| - | If wrong number is entered, Solar Monitor will be unable to show energy output values correctly.\\ | + | [[.:stridace_a_mereni:485|RS 485]]\\ |
| + | [[.:stridace_a_mereni:232|RS 232]]\\ | ||
| + | [[.:stridace_a_mereni:ethernet|Net interface (Ethernet)]]\\ | ||
| \\ | \\ | ||
| - | <WRAP info> If pulses are not shown, check connecting wiring and polarity. </WRAP> **Energy correction** \\ | ||
| - | This box enables initial setting up the Solar Monitor unit with the electrometer. Enter the number of kWh that your electrometer shows. | ||
en/sim/manual/menu_nastaveni/stridace_a_mereni.1406288226.txt.gz · Last modified: 2014/07/25 13:37 by jitka
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
