en:sim:manual:popis:bezpecnostni_upozorneni
Differences
This shows you the differences between two versions of the page.
|
en:sim:manual:popis:bezpecnostni_upozorneni [2018/07/09 15:30] ondra |
en:sim:manual:popis:bezpecnostni_upozorneni [2018/09/12 15:40] (current) ondra |
||
|---|---|---|---|
| Line 15: | Line 15: | ||
| - | Manufacturer accepts responsibility for the device only if it uses power supply provided or approved by manufacturer. | + | Manufacturer accepts responsibility for the device only if it uses power supply provided or approved by manufacturer. \\ \\ |
| + | The connection of signal lines to the inverter must comply with the requirements of ČSN EN 61643-21 + A1, A2 and ČSN EN 62305-1 ed.2. Otherwise, the manufacturer will not be liable for damage to the equipment. | ||
| //Notice:// \\ //To install Solar Monitor system special tools are necessary e.g. crimping pliers for installing RJ45 connector. // | //Notice:// \\ //To install Solar Monitor system special tools are necessary e.g. crimping pliers for installing RJ45 connector. // | ||
en/sim/manual/popis/bezpecnostni_upozorneni.txt · Last modified: 2018/09/12 15:40 by ondra
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
