no way to compare when less than two revisions

Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

@@ Řádek 1: / Řádek 1: @@
+===== Analog Inputs Setup =====
+----
+In case there is no sensor connected to your SM2-AD module, go to [[:en:sim:manual:rozsirujici_moduly:sm2_ad:nast_analog_vystupu|Next >>]]\\
+\\
+\\
+Analog inputs are calibrated. Measurement accuracy at inputs is 0,1.
+Configuration list helps you set up analog inputs correctly. You get the configuration list together with the module SM2-AD.\\
+\\
+{{  :en:sim:manual:rozsirujici_moduly:sm2_ad:ad_konfig_list.png?nolink&300}}\\
+\\
+\\
+A customer specifies in his order measurement range for particular inputs (e.g. 0-20 mV).\\
+\\
+**In case that measurement range has not been specified, all analog inputs SM2-AD are configured in measurement range 0-10V.** \\
+\\
+\\
+\\
+\\
+\\
+\\
+\\
+We can convert the range for measuring e.g wind speed easily.  Let's suppose that 0 m/s = 0 mV and 30 m/s = 15 mV, we have to convert these values into the measurement range:
+"maximum measurement range value"\\
+———————————- * "value representing maximum of measurement range"\\
+"maximum measured range value"\\
+\\
+\\
+In our example (with AI3, measurement range 0-20 mV):\\
+\\
+— * 30 = 40 m/s\\
+\\
+\\
+Enter the result as maximum range value and select the unit displayed with this sensor. Then measured values appear among other sensors.
+{{  :en:sim:manual:rozsirujici_moduly:ad-nastaveni_analogoveho_vstupu.png?nolink&  }}\\
+When you have made the change, please remember to save it.\\
+\\
+{{  :en:sim:manual:rozsirujici_moduly:ad-ulozit_zmeny.png?nolink&  }}\\
+\\
+More examples of how to set up analog inputs to be found [[:en:sim:manual:rozsirujici_moduly:sm2_ad:nast_analog_vstupu:senzor_mencke|here]]. <WRAP right> [[:en:sim:manual:rozsirujici_moduly:sm2_ad:nast_analog_vystupu|Next >>]] </WRAP> <WRAP left> [[:en:sim:manual:rozsirujici_moduly:sm2_ad:spusteni_konfigurace|<< Back]] </WRAP>