This shows you the differences between two versions of the page.
en:sim:manual:rozsirujici_moduly:sm2_gsm [2016/10/19 14:38] ondra |
en:sim:manual:rozsirujici_moduly:sm2_gsm [2018/06/25 13:53] (current) ondra |
||
---|---|---|---|
Line 20: | Line 20: | ||
Open menu “System set up/ E-mail and SMS" in your browser. Tick GSM modem option box and enter phone numbers. Modem is activated in a few seconds and when it has been finished, you can send a trial SMS by clicking on button "Test SMS"..\\ | Open menu “System set up/ E-mail and SMS" in your browser. Tick GSM modem option box and enter phone numbers. Modem is activated in a few seconds and when it has been finished, you can send a trial SMS by clicking on button "Test SMS"..\\ | ||
\\ | \\ | ||
- | {{ .:gsm-web.png?nolink& }}\\ | + | You can find [[.:..:menu_nastaveni:gsm_gprs|here]] how to configurate SM2-GSM. \\ |
- | \\ | + | ==== Specification ==== |
- | In the box bellow you tick the event that you want to be informed of by SMS (e.g. sensor values exceeding permitted range).\\ | + | |
- | \\ | + | |
- | {{ .:gsm-sms.png?nolink& }} | + | |
- | \\ | + | |
- | \\ | + | |
- | \\ | + | |
- | {{ .:gsm_vykres.png?nolink& }} \\ | + | |
- | \\ | + | |
^RF parameters ^ | | ^RF parameters ^ | | ||
|Quad-band | 850/900/1800/1900MHz | | |Quad-band | 850/900/1800/1900MHz | | ||
Line 57: | Line 49: | ||
|Mounting | DIN rail | | |Mounting | DIN rail | | ||
|Screw terminals | 0.5 mm² - 1.5 mm² cable cores | | |Screw terminals | 0.5 mm² - 1.5 mm² cable cores | | ||
+ | |Degree of protection | IP20 | | ||
|Operating temperature | -25 .. +60 °C | | |Operating temperature | -25 .. +60 °C | | ||
|LED diodes | Status, GSM network | | |LED diodes | Status, GSM network | | ||
Line 62: | Line 55: | ||
<sup> 2 ... There is no need for additional power supply if module is connected with the HBUS to the SM2-MU. In this case power supply for the SM2-MU should be calculated to provide sufficient power for all modules on the HBUS. </sup> \\ \\ | <sup> 2 ... There is no need for additional power supply if module is connected with the HBUS to the SM2-MU. In this case power supply for the SM2-MU should be calculated to provide sufficient power for all modules on the HBUS. </sup> \\ \\ | ||
<sup> 3 ... During transmission there can be consumption peak bursts up to 6.4 W. </sup> \\ | <sup> 3 ... During transmission there can be consumption peak bursts up to 6.4 W. </sup> \\ | ||
+ | \\ \\ | ||
+ | {{ .:gsm_vykres.png?nolink& }} \\ | ||