en:sim:manual:menu_nastaveni:stridace_a_mereni
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Obě strany předchozí revizePředchozí verzeNásledující verze | Předchozí verzePoslední revizeObě strany příští revize | ||
en:sim:manual:menu_nastaveni:stridace_a_mereni [2013/12/15 11:09] – jitka | en:sim:manual:menu_nastaveni:stridace_a_mereni [2018/06/08 11:20] – ondra | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
- | ===== Inverters and Meters | + | ===== Find Devices |
---- | ---- | ||
- | + | Submenu | |
- | + | ||
- | Submenu | + | |
\\ | \\ | ||
- | {{ | + | {{ |
- | ==== Setting up connected | + | ==== Setting up communication of connected |
- | **Protocol type** \\ | ||
- | Select your inverter' | ||
\\ | \\ | ||
- | **Transfer speed** \\ | + | Select the type of communication. Relevant |
- | Select | + | |
\\ | \\ | ||
- | **How to find connected inverters** | + | [[.: |
- | Press button Find connected inverters in given interface. Depending on the protocol and inverters number this detection can take as long as several minutes. <WRAP info> In order to be found, inverters must be on, i.e. they must have enough power from the PV panels. </ | + | [[.: |
- | + | [[.: | |
- | + | ||
- | ==== How to set up measuring the energy ==== | + | |
- | + | ||
- | + | ||
- | **Number of pulses per 1 kWh** \\ | + | |
- | Enter the number of pulses per 1 kWh, that your electrometer generates at the SO output. You will find this information at the electrometer label or manual. If you set up wrong value, the Solar Monitor unit will show wrong figures of generated energy. The value is usually 250 or 1000.\\ | + | |
\\ | \\ | ||
- | <WRAP info> If pulses are not shown, check connecting wiring and polarity. </ | ||
- | This box enables initial setting up the Solar Monitor unit with the electrometer. Enter the number of kWh that your electrometer shows. | ||
en/sim/manual/menu_nastaveni/stridace_a_mereni.txt · Poslední úprava: 2018/06/08 11:21 autor: ondra