Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:jak_na_instalaci:steca [2018/05/14 10:42] – ondra
+++ en:sim:manual:jak_na_instalaci:steca [2018/05/25 15:21] (aktuální) – ondra
@@ Řádek 1: / Řádek 1: @@
 ===== Connection Diagram =====
-==== 1a) SM2-MU – master in all cases ====
+==== 1a) SM2-MU – master for all devices ====
-For power supply in Power Supply.
+For power supply see Power Supply section.
 All individual Taroms connected as slaves - data are read from each device.
 {{ .:sm2_mu_steca_slave_scheme.png?direct |}}
@@ Řádek 8: / Řádek 8: @@
 {{ .:sm2_mu_steca_master_scheme.png?direct |}}
 \\ \\
-a) and 1b) can be mixed
+a) and 1b) can be mixed \\
-Both 1a) and 1b) can be used for each SM2-MU interface.
+Both 1a) and 1b) can be used for each SM2-MU interface. \\
+For short cables terminator is not necessary.
 \\ \\
-==== 1d) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ====
+==== 1c) SM2-MU can be placed in the middle of RS485 bus ====
-Second SM2-MU serial interface can be used for additional Tarom device.
+For this case SM2-MU must be used with RS485 terminator switched off. Use yellow DIP switches to achieve this.
+{{ .:sm2_mu_steca_master_scheme_switched_off.png?direct |}}
+\\ \\
+==== 1d) Second SM2-MU serial interface can be used for additional Tarom device. ====
+{{ .:sm2_mu_steca_master_scheme_2_branches.png?direct |}}
+\\ \\
+==== 1e) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ====
+MPPT 6000-S as slaves to MPPT 6000-M
 {{ .:sm2_mu_steca_master_and_slave_connection.png?direct |}}
 \\ \\
-==== 1e) SM2-MU + Tarom 4545 ====
+==== 1f) SM2-MU + Tarom 4545 ====
 {{ .:sm2_tarom4545.png?direct |}}
 \\ \\
 **Detection**
-{{ .:detection.png?direct |}}
+{{ .:detection.png?direct |}} \\ \\
+<WRAP left>
+[[..:jak_na_instalaci:stridace|<< Back]]
+</WRAP>