en:sim:manual:jak_na_instalaci:steca
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Obě strany předchozí revizePředchozí verzeNásledující verze | Předchozí verze | ||
en:sim:manual:jak_na_instalaci:steca [2018/05/14 10:47] – ondra | en:sim:manual:jak_na_instalaci:steca [2018/05/25 15:21] (aktuální) – ondra | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
===== Connection Diagram ===== | ===== Connection Diagram ===== | ||
- | ==== 1a) SM2-MU – master | + | ==== 1a) SM2-MU – master |
- | For power supply | + | For power supply |
All individual Taroms connected as slaves - data are read from each device. | All individual Taroms connected as slaves - data are read from each device. | ||
{{ .: | {{ .: | ||
Řádek 12: | Řádek 12: | ||
For short cables terminator is not necessary. | For short cables terminator is not necessary. | ||
\\ \\ | \\ \\ | ||
- | ==== 1d) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ==== | + | ==== 1c) SM2-MU can be placed in the middle of RS485 bus ==== |
- | Second SM2-MU serial interface can be used for additional Tarom device. | + | For this case SM2-MU must be used with RS485 terminator switched off. Use yellow DIP switches to achieve this. |
+ | {{ .: | ||
+ | \\ \\ | ||
+ | ==== 1d) Second SM2-MU serial interface can be used for additional Tarom device. ==== | ||
+ | {{ .: | ||
+ | |||
+ | \\ \\ | ||
+ | ==== 1e) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S ==== | ||
+ | MPPT 6000-S as slaves to MPPT 6000-M | ||
{{ .: | {{ .: | ||
\\ \\ | \\ \\ | ||
- | ==== 1e) SM2-MU + Tarom 4545 ==== | + | ==== 1f) SM2-MU + Tarom 4545 ==== |
{{ .: | {{ .: | ||
\\ \\ | \\ \\ | ||
**Detection** | **Detection** | ||
- | {{ .: | + | {{ .: |
+ | <WRAP left> | ||
+ | [[..: | ||
+ | </ |
en/sim/manual/jak_na_instalaci/steca.1526287639.txt.gz · Poslední úprava: 2018/05/14 10:47 autor: ondra