Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:menu_nastaveni:stridace_a_mereni [2014/07/25 13:37] – jitka
+++ en:sim:manual:menu_nastaveni:stridace_a_mereni [2018/06/08 11:21] (aktuální) – ondra
@@ Řádek 1: / Řádek 1: @@
-===== Inverters and Meters =====
+===== Find Devices =====
 ----
+Submenu find devices enables setting up connected devices (inverters, MPPT trackers, meters) via RS485, RS232, ethernet interfaces.\\
-Submenu inverters and meters enables setting up inverters and electrometer\\
-\\
-{{  :en:sim:manual:menu_nastaveni:stridace_a_mereni.png?nolink&  }}
-==== Setting up connected inverters according to a particular interface ====
-\\
-Select the type of communication. Relevant information stated in inverter documentation.\\
-\\
-[[:en:sim:manual:menu_nastaveni:stridace_a_mereni:485|RS 485]]\\
-[[:en:sim:manual:menu_nastaveni:stridace_a_mereni:232|RS 232]]\\
-[[:en:sim:manual:menu_nastaveni:stridace_a_mereni:ethernet|Net interface (Ethernet)]]\\
 \\
-==== How to set up measuring the energy ====
+{{  .:stridace_a_mereni.png?nolink&  }}
-**Number of pulses per 1 kWh** \\
+==== Setting up communication of connected devices according to a particular interface ====
-More info on setting up the number of pulses in chapter  [[:en:sim:manual:jak_na_instalaci:elmer|Electro meter]].\\
+Select the type of communication. Relevant information is stated in documentation for the device.\\
 \\
-If wrong number is entered, Solar Monitor will be unable to show energy output values correctly.\\
+[[.:stridace_a_mereni:485|RS 485]]\\
+[[.:stridace_a_mereni:232|RS 232]]\\
+[[.:stridace_a_mereni:ethernet|Net interface (Ethernet)]]\\
 \\
-<WRAP info> If pulses are not shown, check connecting wiring and polarity. </WRAP> **Energy correction** \\
-This box enables initial setting up the Solar Monitor unit with the electrometer. Enter the number of kWh that your electrometer shows.