Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:menu_nastaveni:stridace_a_mereni [2014/08/26 13:42] – ondra
+++ en:sim:manual:menu_nastaveni:stridace_a_mereni [2018/06/08 11:21] (aktuální) – ondra
@@ Řádek 1: / Řádek 1: @@
-===== Inverters and Meters =====
+===== Find Devices =====
 ----
+Submenu find devices enables setting up connected devices (inverters, MPPT trackers, meters) via RS485, RS232, ethernet interfaces.\\
-Submenu inverters and meters enables setting up inverters and electrometer\\
 \\
 {{  .:stridace_a_mereni.png?nolink&  }}
-==== Setting up connected inverters according to a particular interface ====
+==== Setting up communication of connected devices according to a particular interface ====
+Select the type of communication. Relevant information is stated in documentation for the device.\\
-\\
-Select the type of communication. Relevant information stated in inverter documentation.\\
 \\
 [[.:stridace_a_mereni:485|RS 485]]\\
@@ Řádek 20: / Řádek 15: @@
 [[.:stridace_a_mereni:ethernet|Net interface (Ethernet)]]\\
 \\
-==== How to set up measuring the energy ====
-**Number of pulses per 1 kWh** \\
-More info on setting up the number of pulses in chapter  [[..:jak_na_instalaci:elmer|Electro meter]].\\
-\\
-If wrong number is entered, Solar Monitor will be unable to show energy output values correctly.\\
-\\
-<WRAP info> If pulses are not shown, check connecting wiring and polarity. </WRAP> **Energy correction** \\
-This box enables initial setting up the Solar Monitor unit with the electrometer. Enter the number of kWh that your electrometer shows.