Differences

This shows you the differences between two versions of the page.

--- en:sim:manual:rychly_navod:jak_na_to:senzory [2014/08/26 09:24]
ondra
+++ en:sim:manual:rychly_navod:jak_na_to:senzory [2019/08/19 12:44] (current)
ondra
@@ Line 18: / Line 18: @@
 ==== Irradiation Sensor ====
+\\
+In this picture you see to which terminal on the SM2-MU connects each pin of the irradiance sensor. \\ \\
+{{.:osvit_piny_en.png?&250 |}} \\ \\
 <WRAP half column>\\
 \\
@@ Line 56: / Line 57: @@
 <WRAP half column>\\
 \\
+\\
+\\
+\\
+\\
+\\
 \\
-Connect blue silicone cable to the SM2-MU terminals. </WRAP> <WRAP half column> {{  .:senzor_okoli.png?nolink&250  }}\\
+\\
+Connect blue or brown silicone cable to the SM2-MU terminals. </WRAP>
+<WRAP half column> {{  .:senzor_okoli.png?nolink&250  }}
 \\
+\\
+{{ .:senzor_okoli_hnedy_en.png?direct&250 |}}
 </WRAP>\\
 \\
-Solar Monitor can operate up to 10 sensors. The total length of cabling must not exceed 100 meters. In case of multiple sensors connect each cable parallelly into the same terminals.\\
+Solar Monitor can operate up to 10 sensors. The total length of cabling must not exceed 100 meters. In case of multiple sensors connect each cable parallelly into the same terminals.\\ \\
+You can find several connection schemes of sensors [[..:jak_na_to:senzory:priklady_zapojeni|here]].
 \\
-<WRAP right> [[.:stridace|Dext >>]] </WRAP> <WRAP left> [[.:montaz|<< Previous]] </WRAP>
+<WRAP right> [[.:stridace|Next >>]] </WRAP> <WRAP left> [[.:montaz|<< Previous]] </WRAP>