This shows you the differences between two versions of the page.
en:sim:manual:rychly_navod:jak_na_to:senzory:priklady_zapojeni2 [2019/09/02 13:57] ondra created |
en:sim:manual:rychly_navod:jak_na_to:senzory:priklady_zapojeni2 [2019/09/02 14:47] (current) ondra |
||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== 1. The ambient temperature sensor measures the location of the Solar Monitor unit ===== | ||
- | + | ---- | |
+ | <WRAP half column> | ||
+ | The irradiance sensor is connected to the Solar Monitor with a PUR cable with a molded plug at a maximum length of 10 m | ||
+ | ([[https://shop.solarmonitor.cz/en/sensors/47-set-of-sensors-solar-monitor.html#/36-senzory-set_of_sensors_10m_pur_cable_with_m8f_connector|základní sada senzorů - eshop item #100561]]). | ||
+ | </WRAP> | ||
+ | <WRAP half column> | ||
+ | The irradiance sensor is connected to the Solar Monitor using an outdoor PUR cable (length as required) with an M8F connector | ||
+ | ([[https://shop.solarmonitor.cz/en/sensors/47-set-of-sensors-solar-monitor.html#/72-senzory-set_of_sensors_m8f_connector|Basic set of sensors - eshop item #100562]]). | ||
+ | </WRAP> | ||
<WRAP half column> | <WRAP half column> | ||
{{ .:scheme_sensors_1a.png?direct |}} | {{ .:scheme_sensors_1a.png?direct |}} | ||
Line 7: | Line 15: | ||
<WRAP half column> | <WRAP half column> | ||
{{ .:scheme_sensors_1b.png?direct |}} | {{ .:scheme_sensors_1b.png?direct |}} | ||
+ | </WRAP> \\ \\ | ||
+ | <WRAP left> [[.:priklady_zapojeni|<< Back]] | ||
</WRAP> | </WRAP> | ||
+ | <WRAP right> [[.:priklady_zapojeni3|Next >>]] | ||
+ | </WRAP> | ||
+ |