en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Obě strany předchozí revizePředchozí verzeNásledující verze | Předchozí verze | ||
en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu [2014/07/25 10:23] – jitka | en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu [2018/09/14 12:26] (aktuální) – jitka | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
- | ===== Inverter Configuration | + | ===== Step 2 - Interface Settings |
Řádek 5: | Řádek 5: | ||
- | <WRAP half column> | + | Select interface for communication with the inverter |
- | \\ | + | After that click on Next button on the right to get to the next step.\\ |
- | \\ | + | <WRAP info> |
- | \\ | + | |
- | Go to menu Inverters | + | |
- | </ | + | |
- | \\ | + | |
- | <WRAP info> | + | |
- | \\ | + | |
- | <WRAP half column> </ | + | |
- | Select manufacturer of your inverter </ | + | |
- | \\ | + | |
- | <WRAP half column> | + | |
- | \\ | + | |
- | Select data transfer rate. The same data transfer rate must be set up in all inverters and in the Solar Monitor. </ | + | |
- | \\ | + | |
- | When the identification has finished, the list of connected inverters is displayed.\\ | + | |
- | <WRAP half column> | + | |
- | \\ | + | |
- | \\ | + | |
- | \\ | + | |
- | \\ | + | |
- | Remember to save the changes in setup {{: | + | |
- | + | ||
- | + | ||
- | \\ | + | |
- | \\ | + | |
- | For detailed info on inverter' | + | |
\\ | \\ | ||
<WRAP right> [[: | <WRAP right> [[: | ||
en/sim/manual/rychly_navod/konfigurace/konfigurace_stridacu.1406276633.txt.gz · Poslední úprava: 2014/07/25 10:23 autor: jitka