en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Obě strany předchozí revizePředchozí verzeNásledující verze | Předchozí verze | ||
en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu [2014/08/26 10:50] – ondra | en:sim:manual:rychly_navod:konfigurace:konfigurace_stridacu [2018/09/14 12:26] (aktuální) – jitka | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
- | ===== Inverter Configuration | + | ===== Step 2 - Interface Settings |
Řádek 5: | Řádek 5: | ||
- | < | + | Select interface for communication with the inverter and then protocole type and transmission speed.\\ |
+ | After that click on Next button on the right to get to the next step.\\ | ||
+ | < | ||
\\ | \\ | ||
- | \\ | + | < |
- | \\ | + | |
- | Go to menu Inverters & Meters | + | |
- | </ | + | |
- | \\ | + | |
- | <WRAP info> In case of communication with inverters via **RS 232 interface ** or via **Ethernet**, | + | |
- | \\ | + | |
- | <WRAP half column> </ | + | |
- | Select manufacturer of your inverter </ | + | |
- | \\ | + | |
- | <WRAP half column> | + | |
- | \\ | + | |
- | Select data transfer rate. The same data transfer rate must be set up in all inverters and in the Solar Monitor. </ | + | |
- | \\ | + | |
- | When the identification has finished, the list of connected inverters is displayed.\\ | + | |
- | <WRAP half column> | + | |
- | \\ | + | |
- | \\ | + | |
- | \\ | + | |
- | \\ | + | |
- | Remember to save the changes in setup {{..: | + | |
- | + | ||
- | + | ||
- | \\ | + | |
- | \\ | + | |
- | For detailed info on inverter' | + | |
- | \\ | + | |
- | <WRAP right> [[.: | + | |
en/sim/manual/rychly_navod/konfigurace/konfigurace_stridacu.1409043009.txt.gz · Poslední úprava: 2014/08/26 10:50 autor: ondra