Uživatelské nástroje

Nástroje pro tento web


en:sim:manual:rychly_navod:konfigurace:vyhledani_v_siti
no way to compare when less than two revisions

Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.


Předchozí verze
Následující verze
en:sim:manual:rychly_navod:konfigurace:vyhledani_v_siti [2018/09/14 11:25] jitka
Řádek 1: Řádek 1:
 +===== Finding the Unit in the Net, Web Interface Display =====
 +
 +
 +----
 +
 +
 +\\ 
 +SM2-MU unit allows DHCP client regime in the default setting. The IP address is allocated automatically by the DHCP server in local net (if available).
 +
 +
 +In case you don't have DHCP server in your net, for firmware version **2.2.0 Build 51 or higher**follow these steps:\\ 
 +1. In Solar Monitor press button Setup and keep holding.\\ 
 +2. Connect the power supply.\\ 
 +3. When power supply has been connected, wait until Status diode starts flashing green light (takes about 5 sec), let go off Setup button and then press it 3 times.\\ 
 +4. Within 10 seconds you will be able to connect at the permanent IP address [[http://192.168.1.99|192.168.1.99]].\\ 
 +\\ 
 +In case your Solar Monitor has firmware version **older than 2.2.0 Build 5up button1**, follow these steps:\\ 
 +Connect the unit to the power supply and when green LED diode Status starts glowing, press  Setup button 3 times. \\ 
 +<font 12.8px/arial;;#000000;;#ffffff>Within a few seconds you will be able to connect at the permanent IP addres</font> <font 12.8px/arial;;#000000;;#ffffff>s</font> [[http://192.168.1.99|192.168.1.99]].\\ 
 +\\ 
 +When you enter this IP address into your browser, you will find unit's web interface.\\ 
 +\\ 
 +Application **ETool** <font 12.8px/arial;;#000000;;#ffffff>makes finding</font> <font 12.8px/arial;;#000000;;#ffffff>SM2-MU on the net easier.</font> \\ 
 +\\ 
 +This application enables finding your unit with any IP address setting. Application to be downloaded [[http://www.solarmonitor.cz/cz/podpora/ke-stazeni/utility|here]]and then you can install it in your PC.\\ 
 +\\ 
 +{{  :en:sim:manual:prvni_spusteni:etool.png?nolink&  }}\\ 
 +\\ 
 +Button {{:en:sim:manual:prvni_spusteni:etool_tlacitko.png?nolink&}}next to  “IP address“ opens website of chosen unit. See chapter [[:en:sim:manual:prvni_spusteni:zobrazeni_weboveho_rozhrani|Web interface]].\\ 
 +Unit's website can also be opened  with a click on Device Image.\\ 
 +\\ 
 +\\ 
 +<WRAP right> [[:en:sim:manual:rychly_navod:konfigurace:nazev_jednotky|Next >>]] </WRAP>
  
en/sim/manual/rychly_navod/konfigurace/vyhledani_v_siti.txt · Poslední úprava: 2019/02/07 12:19 autor: dusan