en:sim:manual:rychly_navod:konfigurace:vyhledani_v_siti
no way to compare when less than two revisions
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Předchozí verzeNásledující verze | |||
— | en:sim:manual:rychly_navod:konfigurace:vyhledani_v_siti [2018/09/14 11:27] – jitka | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
+ | ===== Finding the Unit in the Net, Web Interface Display ===== | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | \\ | ||
+ | SM2-MU unit allows DHCP client regime in the default setting. The IP address is allocated automatically by the DHCP server in local net (if available). | ||
+ | |||
+ | |||
+ | In case you don't have DHCP server in your net, for firmware version **2.2.0 Build 51 or higher ** follow these steps: | ||
+ | 1. In Solar Monitor press button Setup and keep holding.\\ | ||
+ | 2. Connect the power supply.\\ | ||
+ | 3. When power supply has been connected, wait until Status diode starts flashing green light (takes about 5 sec), let go off Setup button and then press it 3 times.\\ | ||
+ | 4. Within 10 seconds you will be able to connect at the permanent IP address [[http:// | ||
+ | \\ | ||
+ | In case your Solar Monitor has firmware version **older than 2.2.0 Build 5up button1**, follow these steps: | ||
+ | Connect the unit to the power supply and when green LED diode Status starts glowing, press Setup button 3 times.\\ | ||
+ | <font 12.8px/ | ||
+ | \\ | ||
+ | When you enter this IP address into your browser, you will find unit's web interface.\\ | ||
+ | \\ | ||
+ | Application **ETool** <font 12.8px/ | ||
+ | \\ | ||
+ | This application enables finding your unit with any IP address setting. Application to be downloaded [[http:// | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | Button {{: | ||
+ | Unit's website can also be opened with a click on Device Image.\\ | ||
+ | \\ | ||
+ | \\ | ||
+ | <WRAP right> [[: | ||
en/sim/manual/rychly_navod/konfigurace/vyhledani_v_siti.txt · Poslední úprava: 2019/02/07 12:19 autor: dusan