Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:rozsirujici_moduly:sm2_ad:vstupy_a_vystupy [2014/08/06 16:57] – jitka
+++ en:sim:manual:rozsirujici_moduly:sm2_ad:vstupy_a_vystupy [2014/08/26 14:53] (aktuální) – ondra
@@ Řádek 5: / Řádek 5: @@
-Module installation to be found [[:en:sim:manual:rozsirujici_moduly:instalace|here >>]]\\
+Module installation to be found [[..:..:rozsirujici_moduly:instalace|here >>]]\\
 \\
 \\
@@ Řádek 16: / Řádek 16: @@
 Measurement ranges are set up before module is delivered! Correct specification when you order SM2-AD module is essential. It is possible to connect pyranometer (measures solar irradiation), anemometer (measures wind speed) or battery.\\
 \\
-{{  :en:sim:manual:rozsirujici_moduly:ad-analogove_vstupy.png?nolink&400  }}\\
+{{  ..:..:rozsirujici_moduly:ad-analogove_vstupy.png?nolink&400  }}\\
 \\
 Analog output A0 to be connected in the same way. Voltage of 0-10V is detected at output terminals depending on current production or temperature. It can be used for continuous regulation of appliances, e.g. ventilation fan.\\
 \\
-{{  :en:sim:manual:rozsirujici_moduly:ad-analogovy_vystup.png?nolink&300  }}\\
+{{  ..:..:rozsirujici_moduly:ad-analogovy_vystup.png?nolink&300  }}\\
 \\
 Digital (relay) outputs DO to be connected in the same way as with SM2-MU. E.g. to the boiler or storage heater as shown in the picture.\\
 \\
-{{  :en:sim:manual:rozsirujici_moduly:ad-digitalni_vystupy.png?nolink&500  }}\\
+{{  ..:..:rozsirujici_moduly:ad-digitalni_vystupy.png?nolink&500  }}\\
 \\
-<WRAP right> [[:en:sim:manual:rozsirujici_moduly:sm2_ad:spusteni_konfigurace|Next >>]] </WRAP> <WRAP left> [[:en:sim:manual:rozsirujici_moduly:sm2_ad:parametry|<< Back]] </WRAP>
+<WRAP right> [[.:spusteni_konfigurace|Next >>]] </WRAP> <WRAP left> [[.:parametry|<< Back]] </WRAP>