This shows you the differences between two versions of the page.
en:sim:manual:faq [2014/01/02 09:27] jitka |
en:sim:manual:faq [2014/07/24 13:34] (current) jitka |
||
---|---|---|---|
Line 17: | Line 17: | ||
\\ | \\ | ||
- | {{:en:sim:bullet_orange_large.png?nolink&}}**Can I use UTP cable instead of PUR cable? ** \\ | + | {{:en:sim:bullet_orange_large.png?nolink&}}**Can I use UTP cable instead of PUR cable for irradiation sensor? ** \\ |
- | Yes, in short distance (up to 10 m) you can replace PUR cable by UTP cable. | + | Yes, for short distance (up to 10 m) you can replace PUR cable by UTP cable. |
Line 34: | Line 34: | ||
{{:en:sim:bullet_orange_large.png?nolink&}}**Although I have set up LAN in Solar Monitor, there are problems with time synchronization and sending e-mails. Time doesn't synchronize and when I set up the time manually, it changes again. Moreover, e-mails can't be sent. ** \\ | {{:en:sim:bullet_orange_large.png?nolink&}}**Although I have set up LAN in Solar Monitor, there are problems with time synchronization and sending e-mails. Time doesn't synchronize and when I set up the time manually, it changes again. Moreover, e-mails can't be sent. ** \\ | ||
Check box Secondary DNS in unit's web interface [[:en:sim:manual:menu_nastaveni:sit_a_cas|LAN setting]]. | Check box Secondary DNS in unit's web interface [[:en:sim:manual:menu_nastaveni:sit_a_cas|LAN setting]]. | ||
+ | |||
+ | |||
+ | \\ | ||
+ | {{:en:sim:bullet_orange_large.png?nolink&}}**I forgot the password and I am unable to configure the unit. What can I do?** \\ | ||
+ | There is a button Reset at the front panel. Press it 5 times in succession with an interval of approximately 1 sec. Unit setup is completely deleted and default setting renewed. | ||