This shows you the differences between two versions of the page.
en:sim:manual:faq [2014/07/22 09:27] ondra |
en:sim:manual:faq [2014/07/24 13:34] (current) jitka |
||
---|---|---|---|
Line 17: | Line 17: | ||
\\ | \\ | ||
- | {{:en:sim:bullet_orange_large.png?nolink&}}**Mohu pro kabeláž k senzoru osvitu použít UTP kabel místo PUR kabelu? ** \\ | + | {{:en:sim:bullet_orange_large.png?nolink&}}**Can I use UTP cable instead of PUR cable for irradiation sensor? ** \\ |
- | Yes, in short distance (up to 10 m) you can replace PUR cable by UTP cable. | + | Yes, for short distance (up to 10 m) you can replace PUR cable by UTP cable. |
Line 36: | Line 36: | ||
- | \\ | + | \\ |
- | {{:en:sim:bullet_orange_large.png?nolink&}}**Zapomněl jsem heslo a nemohu jednotku překonfigurovat. Jak to mohu vyřešit?** \\ | + | {{:en:sim:bullet_orange_large.png?nolink&}}**I forgot the password and I am unable to configure the unit. What can I do?** \\ |
- | Z čelního panelu zařízení zmáčkněte tlačítko Reset 5x po sobě s intervalem cca 1 sekunda. Nastavení jednotky se celé vymaže a nahraje se tovární nastavení. | + | There is a button Reset at the front panel. Press it 5 times in succession with an interval of approximately 1 sec. Unit setup is completely deleted and default setting renewed. |