This shows you the differences between two versions of the page.
en:sim:manual:menu_nastaveni:gsm_gprs [2018/06/01 15:13] ondra created |
en:sim:manual:menu_nastaveni:gsm_gprs [2019/12/06 08:40] (current) ondra |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ==== SMS Set up ==== | + | ===== GSM / GPRS ===== |
+ | It is set in Solar Monitor in the Settings / GSM/GPRS menu. This mode is disabled in default setting!\\ | ||
+ | {{ :en:sim:manual:menu_nastaveni:gsm_nastaveni.png?direct& }}\\ | ||
+ | \\ | ||
+ | If there is SM2-GSM module connected to the SM2-MU, select appropriate mode in options. | ||
- | **Permit GSM Modem** \\ | + | |
- | If there is a GSM modem connected to the Solar Monitor unit, allow this option.\\ | + | ==== SMS Remote ==== |
+ | |||
+ | |||
+ | In case of having more modules SM2-MU connected in one network and one of them is directly connected to SM-GSM module, all modules SM2-MU are able to send text message reports.\\ | ||
+ | Fill in the box **Remote Gateway ** with the IP address of SM2-MU connected to module SM2-GSM.\\ | ||
+ | Enter recipient's phone number (maximum two recipients) in the following format: +420xxxxxxxxx. You can test the setting and functionality by using a "Send Test SMS" option. | ||
+ | |||
+ | |||
+ | {{ :en:sim:manual:menu_nastaveni:sms_vzdalene.png?direct& }} | ||
+ | |||
+ | |||
+ | ==== SMS (only) ==== | ||
+ | |||
+ | |||
+ | Sending text message report from SM2-MU which is directly connected to SM2-GSM via HBUS.\\ | ||
\\ | \\ | ||
- | **SMS Center Number** \\ | + | If SIM card has PIN, enter the number into box **PIN.** \\ |
- | If your modem is connected, you can see the SMS center number. If you can't see it, you have to set it up at the SIM card ( using another device, e.g. mobile phone).\\ | + | If the module has been connected, the **SMS Center Number ** appears. In case it doesn't appear, you need to set it up correctly on SIM card (in a different device, e.g. a mobile phone).\\ |
- | \\ | + | **Modem State**- shows the status of communication with the modem. If the modem is all right, you can see "ready" in this box.\\ |
- | **Modem Status** \\ | + | <font 12.8px/arial;;#000000;;#ffffff>Enter recipient's phone number (maximum two recipients) in the following format: +420xxxxxxxxx. You can test the setting and functionality by using a "Send Test SMS" option.</font>\\ |
- | Shows history of communication with the modem. Modem is OK if there is " ready" in the box. . <WRAP info> At the SIM card in GSM modem you have to cancel security PIN code! </WRAP> | + | {{ :en:sim:manual:menu_nastaveni:sms_pouze.png?direct& }} |
+ | ==== Data only ==== | ||
- | ==== SMS Recipients ==== | ||
+ | This mode enables communication with the Portal and reporting via email using a data tarif.\\ | ||
+ | <WRAP info> It is useful in locations without permanent internet connection. In that case, use the ethernet connector at SM2-MU only for configuration on PC. When UTP cable is disconnected, the module starts to communicate via GSM. </WRAP> <WRAP important> SIM card must have mobile data tarif. </WRAP> If SIM card has PIN, enter the number into **PIN**.\\ | ||
+ | Enter correct **APN Address ** following your mobile phone operator instructions and **Dialled Number**.\\ | ||
+ | {{ :en:sim:manual:menu_nastaveni:data_pouze.png?direct& }} | ||
- | **1. recipient, 2. recipient** \\ | ||
- | Enter phone numbers of SMS recipients who will receive text messages in this form: +420xxxxxxxxx. If you wish to check that modem and set up works, press the "Send test SMS" button. |