en:sim:manual:prvni_spusteni:vyhledani_jednotky_v_siti_a_pripojeni
no way to compare when less than two revisions
Rozdíly
Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.
Předchozí verzeNásledující verze | |||
— | en:sim:manual:prvni_spusteni:vyhledani_jednotky_v_siti_a_pripojeni [2014/07/25 13:15] – jitka | ||
---|---|---|---|
Řádek 1: | Řádek 1: | ||
+ | ===== How to find and connect unit in the LAN ===== | ||
+ | |||
+ | |||
+ | ---- | ||
+ | |||
+ | |||
+ | \\ | ||
+ | When you have switched on the power supply a green LED diode indicating status lights up. At the same time a green diode at the net connector lights up and an orange diode starts flashing . | ||
+ | |||
+ | |||
+ | In default setting the unit has DHCP client regime granted. DHCP server (if there is one in the local network) assigns IP address automatically. | ||
+ | |||
+ | |||
+ | If there is no DHCP server in your network, connect the unit to the power supply and when the green LED diode Status lights up, press button Setup three times.\\ | ||
+ | In few seconds you will be able to connect to fixed IP address [[http:// | ||
+ | \\ | ||
+ | When you enter this IP address in your web browser, you get into unit's web interface.\\ | ||
+ | To find the unit in the net there is application **ETool** available.\\ | ||
+ | This application is able to find your unit without the IP address settings. Application can be downloaded [[http:// | ||
+ | \\ | ||
+ | **ETool** \\ | ||
+ | \\ | ||
+ | ETool helps to detect your device on the net, configure it, change default setting or restart the device.\\ | ||
+ | \\ | ||
+ | This utility is to be installed in PC with Windows system. It is essential to allow sending broadcast packets through the Windows firewall.\\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | The list shows all Solar Monitor devices connected to the local network. Newly detected devices are highlighted in blue colour.\\ | ||
+ | \\ | ||
+ | When you have selected a device in the list, it is possible to edit its setting and reset default set up.\\ | ||
+ | \\ | ||
+ | Button {{: | ||
+ | You can also open unit's sites when you click on Device image (left down). | ||
en/sim/manual/prvni_spusteni/vyhledani_jednotky_v_siti_a_pripojeni.txt · Poslední úprava: 2020/01/15 10:09 autor: ondra