Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2013/12/19 10:26] – jitka
+++ en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:41] (aktuální) – ondra
@@ Řádek 1: / Řádek 1: @@
-===== Monitoring and alarms =====
+===== Alerts =====
@@ Řádek 5: / Řádek 5: @@
-Menu Monitoring and alarms enables selecting the way of informing the user about alarms.\\
+Menu Alerts enables selecting the way of informing the user about alarms.\\
 \\
-{{  :en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy.png?nolink&  }}
+{{  .:monitoring_a_alarmy.png?direct  }}
-==== PV plant monitoring ====
+==== PV Plant Monitoring ====
-Table shows monitored components of a PV plant, their current status and limit values. It enables setting up the way of informing the user about alarms via e-mail or SMS. You can set up the limit values in the v menu "System set up%%\%%Sensors and alarms", see chapter 4.1.3 Sensors and alarms.\\
+Table shows monitored components of a PV plant, their current status and limit values. It enables setting up the way of informing the user about alarms via e-mail or SMS. You can set up the limit values of sensors in the v menu "System set up%%\%%Sensors and alarms", see chapter 4.1.3 Sensors & Alerts.\\
-\\
-**Loading pulses from the electrometer** \\
-Production is monitored continuously. If no pulses come from the electrometer, countdown starts. When limit value is exceeded, notification is sent to the user.\\
-\\
-**Communication with the inverter** \\
-Inverter's response on line RS-485 is monitored continuously. If there is no response, countdown starts. When limit value is exceeded, notification is sent to the user.\\
 \\
 **Sensors** \\
-If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP> **Inputs** \\
+If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP>
+**Inputs** \\
 When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\
 \\
@@ Řádek 29: / Řádek 24: @@
 \\
 **Sending production report** \\
-A production report (selected type of message) is sent to the user in preset intervals.\\
+A production report (selected type of message) is sent to the user in preset intervals.\\ \\
-==== Inverter status ====
+==== Devices State ====
+If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately.
-If a failure is detected at the inverter ("status" bar), a notification to the user is sent immediately.