Rozdíly

Zde můžete vidět rozdíly mezi vybranou verzí a aktuální verzí dané stránky.

--- en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:40] – ondra
+++ en:sim:manual:dohled_a_upozorneni:monitoring_a_alarmy [2018/06/18 13:41] (aktuální) – ondra
@@ Řádek 16: / Řádek 16: @@
 \\
 **Sensors** \\
-If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP> **Inputs** \\
+If any sensor connected to the unit exceeds the limit values, a notification to the user is sent. <WRAP info> Sensors in default setting have 60 seconds delay, inverters 5 seconds delay. Further info on setting up the delay in chapter 4.1.3 Sensors and alarms. </WRAP>
+**Inputs** \\
 When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.\\
 \\
@@ Řádek 23: / Řádek 24: @@
 \\
 **Sending production report** \\
-A production report (selected type of message) is sent to the user in preset intervals.\\
+A production report (selected type of message) is sent to the user in preset intervals.\\ \\
 ==== Devices State ====
 If a failure is detected at the device (e.g. inverter), a notification to the user is sent immediately.