There are all sensors, inputs and electrometer in the table. To connect the sensors to the unit, run auto-detection - button „ Search sensors“.


Once found, all sensors and the values are displayed. This table enables changing their names, limits and way of informing about exceeding the limits.

Sending message about production
A message about monthly or daily generated energy is sent in selected hour.

Failure of connection with electrometer
In case that Solar Monitor stops receiving impulses from the electrometer in preset interval, this function notifies the user. You can set the delay since the last impulse received.

Monitoring data communication
In case of electrometer connection failure it sends alarm to the portal.

Record alarms into history
Every alarm is recorded in to history if you choose this option (menu Monitoring and alarms \ History of alarms). With this option on, every record in history reduces total capacity of measured values in the unit.

Sending alarms to the portal
If sending is permitted, with each alarm there will be a special packet sent to the portal. The packet contains info about the alarm and current values.

Alarm delay with sensors
You set up the delay between the time when alarm appeared and the time when it is reported. This delay prevents sending many alarm reports with sensor values just about the set values.

Alarm delay with inverters
You set up the delay between the time when alarm appeared and the time when it is reported. This delay prevents sending many alarm reports with inverter values just about the set values.

Irradiation production check
You set up the delay between the time when alarm appeared and the time when it is reported. This delay prevents sending many alarm reports with irradiation values just about the values preset in monitoring. (earlier on this page).