User Tools

Site Tools

This translation is older than the original page and might be outdated. See what has changed.


Finding the Unit in the Net, Web Interface Display

SM2-MU unit allows DHCP client regime in the default setting. The IP address is allocated automatically by the DHCP server in local net (if available).

In case you don't have DHCP server in your net, for firmware version 2.2.0 Build 51 or higher follow these steps:
1. In Solar Monitor press button Setup and keep holding.
2. Connect the power supply.
3. When power supply has been connected, wait until Status diode starts flashing green light (takes about 5 sec), let go off Setup button and then press it 3 times.
4. Within 10 seconds you will be able to connect at the permanent IP address

In case your Solar Monitor has firmware version older than 2.2.0 Build 5up button1, follow these steps:
Connect the unit to the power supply and when green LED diode Status starts glowing, press Setup button 3 times.
Within a few seconds you will be able to connect at the permanent IP addres s

When you enter this IP address into your browser, you will find unit's web interface.

Application ETool makes finding SM2-MU on the net easier.

This application enables finding your unit with any IP address setting. Application to be downloaded here and then you can install it in your PC.

Button next to “IP address“ opens website of chosen unit. See chapter Web interface.
Unit's website can also be opened with a click on Device Image.

en/sim/manual/rychly_navod/konfigurace/vyhledani_v_siti.txt · Last modified: 2019/02/07 12:19 by dusan