User Tools

Site Tools

Trace: • sit_lan

Sidebar

Remote Measurement

  1. Quick Guide
    1. SM2-RM Quick Setup
      1. Installation
      2. Electro Meter
      3. LAN
      4. Digital Inputs
      5. Power Supply
      6. Detecting Unit in a LAN
      7. Unit's Name
      8. Pulses Setup
      9. Inputs Configuration
      10. Sending to Portal
  2. Overview
    1. Basic Characteristics
    2. Module Parameters
    3. Safety Warning
    4. Interface Description
  3. How To Install?
    1. Mechanical Fastening
    2. Connecting Meters
    3. LAN
    4. Digital Inputs
    5. Power Source
  4. How to Start?
    1. Find Device in a LAN
    2. Web Interface
  5. Web
    1. System Setup
      1. Network & Time
      2. Emails & SMS
      3. Inputs & Meters
      4. Alarms
    2. Overview
en:sim:rm:jak_na_zapojeni:sit_lan

This is an old revision of the document!

Local Area Network LAN

In order to communicate with the user, Solar Monitor must be connected to ethernet (LAN). There is one port RJ-45 available, the same as in PC. The unit is connected to the net in the same way as PC.

Connect the unit into LAN(to the switch or PC) with a straight or crossover UTP cable. UTP cables for connecting to LANare available in PC shops.

Straight UTP cable = both ends are the same (T568A)
Crossover UTP cable = T568A + T568B


The device is connected to the net if a green LED light “LINK”at RJ45 terminal of SM2-RM switches on.

en/sim/rm/jak_na_zapojeni/sit_lan.1408110468.txt.gz · Last modified: 2014/08/15 15:47 by jitka

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
CC Attribution-Noncommercial-Share Alike 3.0 Unported Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki