Menu Alerts enables selecting the way of informing the user about alarms.

Table shows monitored components of a PV plant, their current status and limit values. It enables setting up the way of informing the user about alarms via e-mail or SMS. You can set up the limit values in the v menu “System set up\Sensors and alarms”, see chapter 4.1.3 Sensors & Alerts.

Loading pulses from the electrometer
Production is monitored continuously. If no pulses come from the electrometer, countdown starts. When limit value is exceeded, notification is sent to the user.

Communication with the inverter
Inverter's response on line RS-485 is monitored continuously. If there is no response, countdown starts. When limit value is exceeded, notification is sent to the user.

Sensors
If any sensor connected to the unit exceeds the limit values, a notification to the user is sent.

Inputs
When input status (connected / disconnected) changes in a way not allowed by the user, a notification to the user is sent immediately.

Irradiation production check
If irradiation exceeds preset limit value and the inverter doesn't produce power, a notification is sent. Irradiation sensor is essential for this function.

Sending production report
A production report (selected type of message) is sent to the user in preset intervals.

If a failure is detected at the inverter (“status” bar), a notification to the user is sent immediately.