User Tools

Site Tools

This translation is older than the original page and might be outdated. See what has changed.
Trace: • senzory

Sidebar

Solar Monitor User Guide

  1. Quick Setup
    1. Installation
      1. Sensors
        1. Examples of sensor connection diagrams
          1. Example 1
          2. Example 2
          3. Example 3
      2. Inverters
      3. Electrometer
      4. LAN
      5. Digital Inputs
      6. Digital Outputs
      7. Power Supply
    2. Setup Wizard
      1. General Settings
      2. Interface Settings
      3. Sensor detection
      4. Counter Settings
      5. Emails & SMS
      6. Portal Setup
      7. Date & Time
      8. Summary
  2. Overview
    1. Basic features
    2. Parameters
    3. Safety Warning
    4. Interface Description
  3. How to Install?
    1. Mechanical Fastening
    2. Sensors
    3. Inverters
    4. Electrometer
    5. LAN
    6. Digital inputs and outputs
    7. Plugging a power source
  4. Quick Start
    1. Unit discovery in a LAN
    2. Web interface
  5. Factory Reset
    1. How to factory reset?
  6. Web
    1. Overview
      1. Peaks
      2. LCD Panel
    2. Graphs
    3. Alerts
      1. System Log
      2. Power Control Log
      3. Sending History
    4. Settings
      1. Network & Time
      2. Portal
      3. Email & SMS
      4. GSM / GPRS
      5. SNMP
      6. Modbus
      7. Sensors & Alerts
      8. Find Devices
        1. RS 485
        2. RS 232
        3. Ethernet
      9. Inputs & Counters
      10. Outputs
      11. Power Control
      12. HBUS Modules
      13. Backup, CSV, FW
  7. Extension Modules
    1. Installation
    2. SM2-AD
      1. Module Parameters
      2. SM2-AD Installation
      3. Setup
      4. AI Setup
      5. AO Setup
      6. DO Setup
      7. More SM2-AD?
    3. SM2-BE
    4. SM2-DI
    5. SM2-GSM
    6. SM2-PC
en:sim:manual:jak_na_instalaci:senzory

This is an old revision of the document!

Sensors


Solar Monitor unit can connect up to 10 sensors. Maximum length of cables must not exceed 100 meters. Following sensors with cables can be connected. In case of multiple sensors use parallel connection into the same terminal.






For indoor wiring a 6-wire telephone cable with RJ12 connectors is used. You can also use UTP cable CAT5. Use crimping pliers for assembling terminals.

en/sim/manual/jak_na_instalaci/senzory.1385714775.txt.gz · Last modified: 2013/11/29 09:46 by jitka

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
CC Attribution-Noncommercial-Share Alike 3.0 Unported Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki