User Tools

Site Tools

This translation is older than the original page and might be outdated. See what has changed.
Trace: • steca

Sidebar

Solar Monitor User Guide

  1. Quick Setup
    1. Installation
      1. Sensors
        1. Examples of sensor connection diagrams
          1. Example 1
          2. Example 2
          3. Example 3
      2. Inverters
      3. Electrometer
      4. LAN
      5. Digital Inputs
      6. Digital Outputs
      7. Power Supply
    2. Setup Wizard
      1. General Settings
      2. Interface Settings
      3. Sensor detection
      4. Counter Settings
      5. Emails & SMS
      6. Portal Setup
      7. Date & Time
      8. Summary
  2. Overview
    1. Basic features
    2. Parameters
    3. Safety Warning
    4. Interface Description
  3. How to Install?
    1. Mechanical Fastening
    2. Sensors
    3. Inverters
    4. Electrometer
    5. LAN
    6. Digital inputs and outputs
    7. Plugging a power source
  4. Quick Start
    1. Unit discovery in a LAN
    2. Web interface
  5. Factory Reset
    1. How to factory reset?
  6. Web
    1. Overview
      1. Peaks
      2. LCD Panel
    2. Graphs
    3. Alerts
      1. System Log
      2. Power Control Log
      3. Sending History
    4. Settings
      1. Network & Time
      2. Portal
      3. Email & SMS
      4. GSM / GPRS
      5. SNMP
      6. Modbus
      7. Sensors & Alerts
      8. Find Devices
        1. RS 485
        2. RS 232
        3. Ethernet
      9. Inputs & Counters
      10. Outputs
      11. Power Control
      12. HBUS Modules
      13. Backup, CSV, FW
  7. Extension Modules
    1. Installation
    2. SM2-AD
      1. Module Parameters
      2. SM2-AD Installation
      3. Setup
      4. AI Setup
      5. AO Setup
      6. DO Setup
      7. More SM2-AD?
    3. SM2-BE
    4. SM2-DI
    5. SM2-GSM
    6. SM2-PC
en:sim:manual:jak_na_instalaci:steca

This is an old revision of the document!

Table of Contents

Connection Diagram

1a) SM2-MU – master in all cases

For power supply in Power Supply. All individual Taroms connected as slaves - data are read from each device.

1b) Multiple Tarom 6000-M on a single RS485 bus



1a) and 1b) can be mixed
Both 1a) and 1b) can be used for each SM2-MU interface.
For short cables terminator is not necessary.

1d) Other bus cabling example using the MPPT 6000-M, MPPT 6000-S

Second SM2-MU serial interface can be used for additional Tarom device.

1e) SM2-MU + Tarom 4545



Detection

en/sim/manual/jak_na_instalaci/steca.1526287639.txt.gz · Last modified: 2018/05/14 10:47 by ondra

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
CC Attribution-Noncommercial-Share Alike 3.0 Unported Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki