User Tools

Site Tools

This translation is older than the original page and might be outdated. See what has changed.
Trace: • stridace_a_mereni

Sidebar

Solar Monitor User Guide

  1. Quick Setup
    1. Installation
      1. Sensors
        1. Examples of sensor connection diagrams
          1. Example 1
          2. Example 2
          3. Example 3
      2. Inverters
      3. Electrometer
      4. LAN
      5. Digital Inputs
      6. Digital Outputs
      7. Power Supply
    2. Setup Wizard
      1. General Settings
      2. Interface Settings
      3. Sensor detection
      4. Counter Settings
      5. Emails & SMS
      6. Portal Setup
      7. Date & Time
      8. Summary
  2. Overview
    1. Basic features
    2. Parameters
    3. Safety Warning
    4. Interface Description
  3. How to Install?
    1. Mechanical Fastening
    2. Sensors
    3. Inverters
    4. Electrometer
    5. LAN
    6. Digital inputs and outputs
    7. Plugging a power source
  4. Quick Start
    1. Unit discovery in a LAN
    2. Web interface
  5. Factory Reset
    1. How to factory reset?
  6. Web
    1. Overview
      1. Peaks
      2. LCD Panel
    2. Graphs
    3. Alerts
      1. System Log
      2. Power Control Log
      3. Sending History
    4. Settings
      1. Network & Time
      2. Portal
      3. Email & SMS
      4. GSM / GPRS
      5. SNMP
      6. Modbus
      7. Sensors & Alerts
      8. Find Devices
        1. RS 485
        2. RS 232
        3. Ethernet
      9. Inputs & Counters
      10. Outputs
      11. Power Control
      12. HBUS Modules
      13. Backup, CSV, FW
  7. Extension Modules
    1. Installation
    2. SM2-AD
      1. Module Parameters
      2. SM2-AD Installation
      3. Setup
      4. AI Setup
      5. AO Setup
      6. DO Setup
      7. More SM2-AD?
    3. SM2-BE
    4. SM2-DI
    5. SM2-GSM
    6. SM2-PC
en:sim:manual:menu_nastaveni:stridace_a_mereni

This is an old revision of the document!

Table of Contents

Inverters and Meters

Submenu inverters and meters enables setting up inverters and electrometer

Setting up connected inverters according to a particular interface


Vyberte způsob komunikace. Tyto údaje zjistíte z dokumentace ke střídači.

RS 485
RS 232
Síťové rozhraní (Ethernet)


How to set up measuring the energy

Number of pulses per 1 kWh
Více informací o nastavení počtu pulzů naleznete v kapitole o Elektroměru.

V případě zadání chybné hodnoty bude Solar Monitor zobrazovat špatné údaje o vyrobené energii.

If pulses are not shown, check connecting wiring and polarity.

Energy correction
This box enables initial setting up the Solar Monitor unit with the electrometer. Enter the number of kWh that your electrometer shows.

en/sim/manual/menu_nastaveni/stridace_a_mereni.1406019055.txt.gz · Last modified: 2014/07/22 10:50 by ondra

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
CC Attribution-Noncommercial-Share Alike 3.0 Unported Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki