User Tools

Site Tools

This translation is older than the original page and might be outdated. See what has changed.
Trace: • spusteni_konfigurace

Sidebar

Solar Monitor User Guide

  1. Quick Setup
    1. Installation
      1. Sensors
        1. Examples of sensor connection diagrams
          1. Example 1
          2. Example 2
          3. Example 3
      2. Inverters
      3. Electrometer
      4. LAN
      5. Digital Inputs
      6. Digital Outputs
      7. Power Supply
    2. Setup Wizard
      1. General Settings
      2. Interface Settings
      3. Sensor detection
      4. Counter Settings
      5. Emails & SMS
      6. Portal Setup
      7. Date & Time
      8. Summary
  2. Overview
    1. Basic features
    2. Parameters
    3. Safety Warning
    4. Interface Description
  3. How to Install?
    1. Mechanical Fastening
    2. Sensors
    3. Inverters
    4. Electrometer
    5. LAN
    6. Digital inputs and outputs
    7. Plugging a power source
  4. Quick Start
    1. Unit discovery in a LAN
    2. Web interface
  5. Factory Reset
    1. How to factory reset?
  6. Web
    1. Overview
      1. Peaks
      2. LCD Panel
    2. Graphs
    3. Alerts
      1. System Log
      2. Power Control Log
      3. Sending History
    4. Settings
      1. Network & Time
      2. Portal
      3. Email & SMS
      4. GSM / GPRS
      5. SNMP
      6. Modbus
      7. Sensors & Alerts
      8. Find Devices
        1. RS 485
        2. RS 232
        3. Ethernet
      9. Inputs & Counters
      10. Outputs
      11. Power Control
      12. HBUS Modules
      13. Backup, CSV, FW
  7. Extension Modules
    1. Installation
    2. SM2-AD
      1. Module Parameters
      2. SM2-AD Installation
      3. Setup
      4. AI Setup
      5. AO Setup
      6. DO Setup
      7. More SM2-AD?
    3. SM2-BE
    4. SM2-DI
    5. SM2-GSM
    6. SM2-PC
en:sim:manual:rozsirujici_moduly:sm2_ad:spusteni_konfigurace

This is an old revision of the document!

Start and Configuration

When the modules have been connected and Solar Monitor has been connected to the power supply, green LED diode Status must glow.

If the diode is not glowing, check connection of the module and SM2-MU. Open menu “System Setup / Inputs and Outputs in your web browser.



Next >>

<< Back

en/sim/manual/rozsirujici_moduly/sm2_ad/spusteni_konfigurace.1409057762.txt.gz · Last modified: 2014/08/26 14:56 by ondra

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 3.0 Unported
CC Attribution-Noncommercial-Share Alike 3.0 Unported Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki